INCREASE WIFI SIGNAL WITH KALI 2
Increase Wifi Signal Strength Tx-Power On Kali Linux Step by step Increase Wifi Signal Strength(TxPower) on Kali Linux: 1. Open up our terminal and type ifconfig and make sure your wireless network already detected and up. 2. Now let's check our wireless card default tx-power by running this command iwconfig wlan0 the default tx-power of my wireless card is 20 dBm . STEP 2: 3. When we check the default signal quality through wavemon, 4. To change the tx-power we must turn off our wireless interface by running ifconfig wlan0 down and then change the regional to BO (Bolivia) which in that country they allow the use of 1000 mW tx-power iw reg set BO turn on the wireless interface again ifconfig wlan0 up 5. Now we can check again our wireless card status by running iwconfig wlan0 if the tx-power already changed, let's check our wavemon, and see the difference. 6. We can set up our wireless card into specific channel by ru...